Product Description
Daytime Running Light DRL / Fog Light Plug and Play Adapter Harness
for GM Chevrolet Chevy Camaro 2010-2015
*Fits: 2010-2013 Camaro V6/RS & SS/RS
*Fits: 2012-2015 Camaro ZL1
This DRL harness will allow you to utilize your factory day time running lights as fog lights. With this harness you will now be able to operate the factory halo and the fog lights at the same time when you turn the headlight switch to the "Parking" light position. Under normal operation with this harness and the factory light sensor the day time running lights, or fog lights, will always be ON. This harness will require your Camaro to have the "RS" package installed.
How do you know if you have the "RS" package installed on your Camaro?
The easiest way to tell is if your headlights have the factory "halo" installed from the factory, this will signify that you have the "RS" package. Most 2010-2013 V6 models are also signified by the Red "RS" emblem in the front grill or the rear trunk lid. Most 2010-2013 SS models are also signified by the Red "SS" emblem in the front grill or the rear trunk lid. All 2012-2015 ZL1 models have the "RS" package.
Installation is done by simply removing the 3 torx screws and pulling back your factory fender liner on the Passenger side. Once pulled back you can access the main factory harness and plug the HERO harness in place with the factory connectors.
Features:
Easy installation
No modification required
Plug and play harness
Built in diode
Note: Harness will only work on models equipped with the factory "RS" package. US Spec Vehicles Only.
Install: Install only takes 5 minutes!! NOTE: Installation will take place on the passenger side of the vehicle!!
1 - Turn front wheels all the way to left to gain access to the screws on the passenger side fender well.
2 - Remove the 3 (T20) torx screws holding the fender well plastic liner in place ( orx T20 Needed for Install ) ZL1 owners also need to remove the 3 screws under the front bumper.
This will allow you to access forward lamp harness connector.
3 - Disconnect the forward lamp harness.
4 - Plug the plug and play DRL harness inline
5 - Reconnect the other end of the harness to our harness.
6 - Verify operation. With headlamps on your DRL's should also be on.
7 - Reinstall fender liner screws.
