Product Description
Single Replacement Johnson 2126LSR Lifter
Slow Leakdown Link-Bar Hydraulic Lifters for all LS-Based Engines
This listing is for ONE PAIR (a single link bar) of 2126LSR lifters. 8 Pairs required per engine.
Johnson's slow leak down race-style lifters with axle oiling for all LS engines not running DOD/AFM. Ideal lifter for users looking to push their LS engines past 7000rpm. #2126LSR is a link-bar design that does not use the factory plastic lifter guide trays.
-
Hydraulic-Roller -
Will accommodate higher open spring pressures of 500+lb -
Link Bar -
.093" Total Plunger Travel -
.035" Recommended Pre-Load +-.010" -
This listing is for a single link bar (2 lifters). Ideal for replacing damaged lifters.
Recommended Lifter Installation:
1. Inspect the lifters for any signs of damage to the lifter body or wheel.
2. Verify the rollers spin without any binding.
3. Wipe down the lifter body with a lint free rag.
4. Coat the outside of the lifter with engine oil (not recommended to soak)
5. Debris entering a lifter is the main cause of failure. Clean the top end of the engine to ensure no foreign debris can enter the lifters upon startup.
6. Inspect the Rocker Arms, Pushrods Ends, and Valve Tips for excessive wear. Replace as necessary.
7. Install lifters and set the lifter preload to the recommended specifications.
8. Change oil/filter after 50 miles to remove any debris that may have been missed during assembly.
